Error with CCE SP2 and Rebuilder 1.10.6

@jdobbs Do you think this would affect my error messages too? Cu Rippraff

Very possibly.

Okay thanks. :) I'll give it a go the next days with the test version. At the moment the first test encode is still running at 46% on my old AMD XP-M. Cu Rippraff

Well I was going to install the trial version of CCE SP2 but it refuses to install on my core 2 duo E6600 system. I keep getting an error that the setup can't detect SSE and therefore won't install. Anyone else with a Core 2 Duo had this problem with CCE SP2? BTW CCE Basic 2.70 installs and runs fine

CCE SP2 works fine to me, with 1.10.6

Thanks a lot for yout great work. CCE-SP2 works fine with DVDRB 1.10.6. Keep up your excellent job, jdobbs.

@kbello & @rocky29, Either of you two guys using a core 2 duo chip? cheers

It was The wire Season 1 disc 4. But the disc was already downsized, I just tested with that one since I had it lying around on my HD. Maybe that has something to do with it? I will try with a full DVD9 after work. I used the default settings for CCE. And to you guys that have problems with Core Duo CPUs. I also have a T2500 Core Duo, and the first build of CCE SP2 didn't work properly. I got the SSE/Enhanced 3D Now error when trying to install. I downloaded build 04, and it works just fine.

Could you try the EXE in Post #6 and see if it helps... Thanks.

@therat, I did not use core2 duo chip. Very good work,jdobbs, Thanks again